Check for the latest compatible SD cards. Class 10 high-endurance cards from reputable brands are recommended for constant video recording of a dash camera. Please be sure to format the card in-camera before use. This camera is compatible with Micro SD cards up to 256GB. Extract the card and replace it as necessary by inserting a card into the slot and pressing it until it locks in place. There will be a click and the SD card will pop out on release. To remove the SD card, press firmly on the SD card to push it further into the slot.
The device comes with a Micro SD memory card. To ensure that important footage is not lost surrounding an incident, the adjacent video clip is locked if the incident happens within 30 seconds of the beginning or end of a clip. Emergency Recordings create locked files that are not overwritten by Continuous Loop Recording. EMERGENCY RECORDINGS:Īn Emergency Recording is triggered when the Emergency Record/Favorites Button is pressed or when the G-Sensor registers a significant impact (hard braking or collision). To manually power on the device PRESS AND HOLD the Power button until the display activates.Ī Hardwire Kit is available at for a more permanent installation that allows for discrete routing of the power cable and recording while your vehicle is off. The unit will automatically turn on and start recording. Plug one end of the supplied 12V Vehicle Power Adapter into your vehicle’s cigarette lighter, and the other end into the micro USB port. Screw mounting is recommended for the most secure hold. Mount the camera using the mounting screws or adhesive pad as needed. Use the included cable routing clips to route the extension cable to the desired mounting location. Please orient the rear camera so it faces out the windshield as shown here.Ĭonnect the Extension Cable to the Video Input Port on the Dash Cam. Connect the Extension Cable to the Rear Camera and attach it to the vehicle’s back window. For a View of the Road Behind YouĬonnecting FV-RV1 Rear Cam Connect Extension Cable to the Video Input Port on the Dash Cam and run the cable along the floor of your car. Next, peel the plastic film off the 3M adhesive and press the mount FIRMLY onto the windshield.
Reminder, this is an adhesive mount, so it is important to mount it correctly the first time. Find the spot on your windshield where you would like to mount the camera and confirm the placement. Remove the protective film from the camera lens and display. To install the Adhesive Windshield Mount, slide the dash cam onto the mount.
0 kommentar(er)
